Xantech 79000 Multiple Emitter Connecting Block

CB18 Strip-IR™ Parallel Connecting Block from Xantech

• Easily connect all those home run wires from multiple IR receivers to the input terminals of a connecting block.
• High current design (12 amps peak) allows amplifiers rated as high as 500W to be used with the CB18.
• One-in and eight-out or eight-in and one-out capability.
• Nine 4-terminal plug-in connectors on 4-conductor bus.
• Screw terminals handle wire sizes from 24 to 12 gauge.

CB20 One-Zone Connecting Block from Xantech

• Connects two emitter ports and power supply to Xantech IR receivers that use a stereo mini plug.
• 3.5 mm stereo mini jack for quick-connect IR receivers
• Two 3.5 mm mono mini jacks with 470 ohm resistors drive 2 single or 2 dual emitters
• 2.1 mm coaxial power jack
• Requires either the 781RG or 782-00 power supply.

CB60 One-Zone Connecting Block from Xantech

• Connects six emitter ports and power supply to all Xantech IR receivers that use a stereo mini plug.
• 3.5 mm stereo mini jack for quick-connect IR receivers.
• 3.5 mm mono mini emitter ports drive 6 single or 6 dual emitters in parallel.
• Contains a series 100 ohm resistor per emitter port.
• Requires either the 781RG or 782-00 power supply.

IRS232 IR to RS232 Module from Xantech

• Provides IR control of advanced components such as projectors and lighting systems.
• Requires 781RG power supply; RC68+ programmer and Dragon Drop-IR™ programming software.

IR-X10 Lighting Module from Xantech

• Converts specific Dragon Drop-IR™ codes into X10 control signals.
• IR input accepts Xantech IR bus output from any of the Xantech IR receivers; keypads; connecting blocks or controllers.
• X10 RJ11 output jack connects to the X10 power line interface module using the included RJ11-to-RJ11 cable.
• Requires a 781RG power supply and Dragon Drop-IR™ programming software.

MAC1 Mini-Macronizer™ from Xantech

• Has the ability to send IR codes; sequences or macros when triggered by a single RC68+ command.
• Requires Dragon Drop-IR™ for programming and 781RG power supply.
• Eliminates the problem of partial sequence execution from movement of hand-held controllers.
• Cuts down network traffic.