Xantech 490-95KIT Plasma / Sunlight / Fluorescent Tube Light-Friendly Micro Link™ Receiver with Power Supply & Emitter

The 490-95 is designed to reject interference from Plasma Displays from entering the IR signal line. These Small IR Receivers are intended to be mounted in panels, doors, cabinets, etc. for control of A/V equipment behind closed doors or any IR Repeater System that is in close proximity of a Plasma or LCD Displays. Modeled after the original 490-90, the 490-95 offers the same features as its predecessor but in a smaller mounting frame. Besides showing great immunity to Plasma emissions, the 490-95 (as wells as all Xantech Plasma-Friendly Receivers) work well in the presence of Sunlight and Fluorescent lighting. Their wide-bandwidth reception allows them to be used with a much wider assortment of IR Controllable products than the competition assuring the 'job will get done' the first time around without un-wanted service calls.

These units, equipped with a 7-foot cable and 3.5 mm stereo mini plug, are intended to be plugged directly into the "IR RCVR" or "AUX" jack on Xantech Connecting Blocks, such as the CB12(included), CB60, 789-44, 791-44, etc. The 490-95 should be used in installations where the connecting block is within reach of the 7-foot cable -- such as when installing the 490-95 in a cabinet where the controlled equipment is behind closed doors.

Placement of the IR Receiver does matter when used in the presence of a Plasma Display. Ideally it should be placed at areas around the Display with the front of the receiver flush with the front of (or set back from) the Display. If the 490-95 needs to be placed in front of the display (such as on an adjacent side wall perpendicular to the display),

• Small size; mounts in ¾" diameter hole. 2¾ inches deep (70mm)
• Quick-Connect 3.5mm Stereo Mini Plug on 7ft. (213.36cm) cable for direct plug-in to Xantech Connecting Blocks
• Works in normal 3-wire mode (12VDC, IR, GND)
• Green Talkback LED for System Verification
• Improved Fluorescent Light rejection (under most conditions) and rejection from LCD Displays
• Can be used in Direct Sunlight
• RF Grid included for EMI interference reduction
• Includes CB12 Connecting Block for easy connection and extension of 7' ribbon cable
• 7 units may be powered by one 781RG power supply Note: The 490-95 will not operate in 2-wire Phantom Power mode

• Infrared modulation frequency bandwidth: 30 - 100 kHz
• Reception range: up to 55 feet (17M), depending on local conditions
• Reception angle: 55 degrees off axis for 50% range reduction
• Cable requirements: 3-conductor. Use 24 gauge up to 200' (61M), 22 gauge up to 600' (182.5M), 20 gauge up to 1000' (305M), 18 gauge up to 2000' (610KM) -- unshielded OK)
• Maximum transmission length: One mile using 18 gauge wire (1.6KM)
• Maximum current output: 100 mA
• Dimensions: 0.75" diameter x 2.75" deep (19mm x 70mm)
• Power requirements: 12 volts DC @ 20 mA