Leviton 48210-0VA Video Amplifier Module

Run cable TV, an antenna, or other modulated input through this Video Amplifier Module and boost video signal strength up to 25 dB. Features a variable attenuator for signal amplification level setting, and an FM trap to eliminate unwanted FM interference.

1x4, 1x6, 1x8 Coaxial Cable Distribution Modules

Use 4-, 6- and 8-way Coaxial Cable Distribution Modules to split digital cable (2.05 GHz units), quality cable TV and off-air antenna signals to 4, 6, or 8 televisions throughout the home or office. They feature die-cast housing and printed circuit board construction.

Leviton 3x4 Multi-Switch Module

The 3x4 Multi-Switch distributes satellite signals from dual incoming LNB (Low Noise Block Converter) Digital Satellite Systems to up to four satellite receivers. The module also incorporates a separate input to receive TV antenna signals. (Best used in combination with a Video Amplifier such as Leviton’s 48210-VA.) Easy to install.

RF Notch Filter

The RF Notch Filer blocks incoming cable TV channels 75-80, allowing the Media Center Modulator or Component Modulator to broadcast an in-house "security" or "entertainment" channel without interference. The Notch Filter simply couples to the coaxial cable TV input on either a splitter or an active video distribution device such as the Leviton 3x8 Bi-Directional Video Amplifier (47690-38B). Once installed, it filters out six cable channels to make room for any home security or entertainment video application. It also blocks outgoing signals, such as cameras, from being broadcast outside the home.

Multi-Room Infrared (IR) Repeater System

The IR Repeater System consists of three pieces: an IR Target, IR Emitter and a distribution block for distributing control signals to multiple emitters. The IR Target takes the signal from a remote control for an audio/video component and converts it to a low-voltage electrical signal for use over long distances and in different rooms. The electrical signal is converted back at the component to be controlled by the IR emitter. The IR Target easily installs in the ceiling or wall, and connects with Category 5 cable to the IR Emitter. A separate IR Emitter is used for each controlled A/V component, through the distribution block in the Structured Media Center.

Multi-Room Infrared (IR) Repeater System

The IR Repeater System consists of three pieces: an IR Target, IR Emitter and a distribution block for distributing control signals to multiple emitters. The IR Target takes the signal from a remote control for an audio/video component and converts it to a low-voltage electrical signal for use over long distances and in different rooms. The electrical signal is converted back at the component to be controlled by the IR emitter. The IR Target easily installs in the ceiling or wall, and connects with Category 5 cable to the IR Emitter. A separate IR Emitter is used for each controlled A/V component, through the distribution block in the Structured Media Center.

48210 Decora Media™ System Transmitter / Receiver Pair

Distribute Audio and Video signals anywhere in the home using Category 5 Cable and Leviton’s Decora Media System (DMS). Send VCR, DVD, cable TV, satellite and security camera signals through up to 1,000 feet (300 meters) of cable with no discernable audio or video distortion and better performance than the more expensive, specialized “designer" cables.

DMS is comprised of: a Send Unit for transmitting audio/video signals, a Receive Unit for receiving signals, and a Media Hub for whole house distribution.

Order Hub separately

Special order item. Non-returnable or subject to restocking fees