ELK Products ELK-9100 240V, X-10 Controlled Relay

Remote Controlled Heavy Duty Switch 30 Amp, 240VAC Relay Controlled by X-10: Built-in Signal Bridge, and Repeater Function

The ELK-9100 ULTRAMATE is a remote controlled heavy duty switch which may be used with 220/240 Volts A.C. electrical appliances, water heaters, pool pumps, or 110/120 branch lighting loads. It can be activated by an X-10 power line signal or contact closure source. The unit features built-in signal bridging across both legs of the 220/240 power circuit for improved performance of X-10 powerline signaling. It also features a selectable repeater function to provide more reliable X-10 communications over longer distances.

ELK-930 Door Bell & Telephone Ring Detector from ELK Products

The ELK-930 performs three functions. It can detect ring activation from one or two doorbell buttons and a single telephone line. It conveniently isolates the voltage and current and produces an open collector (pull to ground) output which can be used to trigger an automation controller, relay, timer, etc. The circuit is pre-scored so that the individual detectors may be snapped off (separated) from each other.

The ESM1 listens to your power line, and displays signal strength of any activity at the X-10 frequency. It also measures and displays any signal between 100mV and 5 volts (The maximum specified X-10 signal strength). The bar graph LED readout shows signal strength level, while the "X-10 Good" light indicates whether valid X-10 traffic is being received. The ESM1 is the best value choice for test tools.

ELK Products ELK-WSV Water Shutoff Valve

STOP! water damage caused by broken pipes, leaking or broken hoses from washing machines, ice makers, toilets, water heaters, etc.

The ELK-WSV is a Professional Grade, electrically operated water shutoff valve for both residential and commercial use. Used in conjunction with an automation controller, leak detection devices, or a simple manual pushbutton, the WSV can easily and conveniently shut off the main water supply to the building. Unlike competitors units, the ELK-WSV is a stainless steel, 1" full bore, ball valve with commercial grade seats and seals. It is a "non-restricting" valve which meets the approvals of state and municipal water authorities. The motorized actuator has a permanently lubricated gear drive with sufficient torque to open or close the valve under high pressure or after long periods of inactivity. The ELK-WSV valve can be operated via a simple 12 Volt DC input from a security or automation controller such as the ELK-M1 Gold or M1EZ8. It can also be attached directly to a 12Vdc power source through a SPDT Emergency Pushbutton or "Easy: button for manual control. Operating time from fully open to fully closed is less than 5 seconds.