Avalan Wireless AW900x 900 MHz point-to-point Ethernet bridge: Outdoor, NON-Line-of-Sight
Description
The AW900x replaces costly wiring with a wireless Ethernet bridge that can enable remote Wi-Fi APs, Ethernet pan/tilt/zoom security cameras, VoIP phones or Internet Kiosks. AvaLAN's product offers the ideal combination of price, range, data rate, security, interference avoidance, quality-of-service and ease-of-use.
The best solution when
- A Broadband Ethernet drop will cost too much or is impractical to install.
- Guaranteed DSL-rate throughput is required. (Kiosks / Wi-Fi APs / PTZ Cameras)
- Guaranteed latency for voice or video is required. (PTZ Cameras / VoIP)
- Wi-Fi is too slow due to saturation or 2.4Ghz interference. (Airport / Mall / PTZ Cameras)
- Ultra low current consumption is required. (1 Watt - Solar powered systems)
AW900x Long-range 900MHz wireless outdoor Ethernet bridge. Kit includes:
- (2) AW900x NEMA-4x radios
- (2) 110-220 VAC to 9 VDC power supplies
- (2) 30ft outdoor grade CAT5 cables
- (2) Power over Ethernet injectors
- (2) wall mounting kits.
- Requires Antennae – use with AW15, AW11, AW8 or AW6 – all FCC approved
Features
- Foliage penetrating, non-line-of-sight wireless Ethernet bridging.
- Does not interfere with Wi-Fi networks.
- Highest Quality of Service (QoS) available - Synchronous point to point protocol enables extremely low data latency and jitter.
- 128bit encrypted payload protection provides secure data delivery.
- Simple plug and play - pre-configured as matched pairs with no user programming required.
- Power over Ethernet Enabled
- Operates in the 902-928MHz band and does not require an FCC license to operate or install.
- VLAN extensions supported.
Specifications
| Characteristic | Specification – description (typical) |
| RF transmission rate: | 1.5 Mb/s |
| Throughput: | 935 Kb/s |
| Output power: | 4 watts EIRP with 15dBi antenna - +21dBm at antenna port |
| Receive sensitivity: | -112 dBm at 10e-4 BER with 15dBi antenna |
| Latency: | < 2ms – assuming a dedicated wireless link to client device. |
| Jitter: | +/-0.5ms – depending upon packet size, interference and SNR. |
| Power consumption: | RX 0.6 W, TX 1.4W |
| Voltage: | 4 to 48 VDC |
| Radio channels: | 12 Non-overlapping |
| Automatic frequency select: | Yes – radio channel automatically selected and adaptively optimized |
| Status LEDs: | Power, RF Link, Ethernet Link, Traffic, RF RX, RF TX, 4/Channel and 6/Link Quality |
| MAC pass-through filter: | Yes – can be disabled |
| Error correction technique: | Sub-block error detection and retransmission |
| Adjacent-band rejection: | SAW receiver filter attenuates cellular and pager interference. |
| Enclosure Type: | NEMA 4X |
| Temperature range: | -40ºC to 70ºC |
| Power over Ethernet: | Includes injectors/power supplies. 9 to 48 VDC ready |
Ordering Information
| Part No. | Description | Contents |
| AW900x | Outdoor Long Range Wireless Ethernet Bridge | 2 Radios, 2 power supplies, 2 POE injectors, 2 wall mounting kits, 2 30ft outdoor grade CAT5 cables |
| AW11 | 11dBi antenna | 11dBi Yagi antenna – Includes wall mounting hardware, 10in RPTNC pigtail |
| AW15 | 15dBi antenna | 15dBi Yagi antenna - Includes wall mounting hardware, 10in RPTNC pigtail |
| AW-XPM | pole mounting bracket | Includes: one pole mounting bracket for up to 2" pipe. AW15 or AW11 antenna can be mounted directly to this plate. |
|
