AirVac VM118-100 Nail Guard Accessory (100-pack)

The Model VM118-100 Nail Guard Accessory (100-pack) is a shield that can be nailed on a wall stud over the area where the central vacuum piping passes. The shield protects the central vacuum piping from getting punctured by drywall screws and nails during construction.

AirVac VM123 Flexible Central Vacuum Hose (10-inch)

The Model VM123 Flexible Central Vacuum Hose (10-inch) is a 10-inch length of wire reinforced 2-inch diameter flexible hose. This hose is typically used to connect the central vacuum power unit intake port to the system's main vacuum tube. Use Model VM124 Hose Clamps to connect the hose.

AirVac VM124 Hose Clamp

The Model VM124 Hose Clamp is a 2-inch diameter metal hose clamp used for securing Model VM123 Flexible Central Vacuum Hose.

AirVac VM136-25 Exhaust Vent Cap (25-pack)

The Model VM136-25 Exhaust Vent Cap (25-pack) is a white PVC cap with three louvers designed to terminate the central vacuum's exhaust system. The exhaust system routes the exhaust air from the central vacuum power unit to outside the residence. When the central vacuum system is off the vent cap's louvers are closed, preventing rain and insects from entering the exhaust system. When the central vacuum system is running, the louvers automatically open to pass the exhaust air to the outside. The exhaust vent cap mounts to the wall with four screws and connects to the system's steel or PVC exhaust tubing.

AirVac VM198-15 Cover Plate (15-pack)

The Model VM198-15 Cover Plate (15-pack) is a white cover plate that screws to a wall inlet valve bracket for new construction or future system expansion. The plate seals the wall valve bracket.

AirVac VMRC2 Vacuum Wireless Remote Control System

The Model VMRC2 Vacuum Wireless Remote Control System allows controlling the Central Vacuum power unit remotely without using a hose-wired control switch. The VMRC2 kit containg a wireless transmitter a wireless receiver, and a mounting clip for the transmitter. The transmitter installs into the mounting clip that snaps onto the vacuum wand. The receiver mounts near the central vacuum power unit.

Linear WET-2 Water-resistant Transmitter Kit